Job Description

THIS IS A TEMPORARY CONTRACT POSITION UNTIL DECEMBER 19, 2025

Requirements

High school diploma, GED or equivalent required. 3 shift rotation (midnights, afternoons, days). Production experience preferred. Communicate in English (orally and in writing).

Job Duties

Between racking sessions, must ensure all required empty dunnage is provided to final audit, and all full dunnage is removed in a timely manner. Between racking sessions, repack parts as necessary following repack priority schedule. Must be able to load and unload pistons from plating racks to required quality and production standards. When unloading the rack, start from bottom row up loading only one piston in each hand at a time. When loading racks ensure to load only one piston in each hand to prevent handling marks. Must be certified as a relief operator for Grinder Operator and Press Operator and follow safe operating procedures (specific to Maple Manufacturing). Assist pollution as required (Plater crashes). Rotate inventory to ensure First in First out (FIFO) prior to changeover. Assist with rack maintenance and repair or change damaged clips as required. Understand and adhere to the control and containment procedure for non-conforming or suspect non-conforming product. Understand and adhere to the scrap protocol procedure. Perform all related housekeeping procedures. Ensure Forklift pre-operational checklists done daily. Understand and adhere to Escalation Process. Follow rack and hanger condition/preventative maintenance process. Offload during break coverage is to be performed by utilizing one piston in each hand. There is to be no banging, knocking, or hitting of pistons while offloading. Compliance to all safety rules as well as company policies. Other duties as assigned by management.
Start-Up Duties

When requested, assist Line Lead in required duties: Waste treatment probe calibration. Nickel filter charge. Other duties as required by management. Hanger Preventative Maintenance: Wipe excessive grease form all hangers. Check all hangers on the hanger gauge; select the best conditions hangers for use on the line. The remaining hangers are to be sent to maintenance for service. Clean hangers to rack contacts on the hangers that are selected to be used in the plater at the four contact areas with emery cloth. Consult Line Lead if necessary. Rack Preventative Maintenance: Clean any grease from the racks, at hanger contact and from coating, to be run per production schedule. Clean matching hanger to rack contact point with emery cloth. Remove excess "treeing" from contacts, flags, or shields being careful not to further damage rack coating. Straighten and adjust any part pins requiring adjustment for proper part contact. Consult Line Lead if necessary. Set up racking/unracking area as necessary for next production run as per production schedule. Clean rust preventative spray unit, take special care when cleaning optic sensors. Sweep and mop floors in plating and final audit area. Empty garbage. Set up final audit area with required packaging as per production schedule. Flush eyewash stations and emergency showers until water runs clear at platers and parts washers. Clean fire extinguisher covers.

We thank all applicants for their interest, however only those candidates selected for interviews will be contacted.

Job Types: Full-time, Fixed term contract
Contract length: 2 months

Pay: $21.78-$23.06 per hour

Benefits:

Casual dress On-site parking
Education:

Secondary School (required)
Licence/Certification:

Grade 12 Math (preferred)
Work Location: In person